24/7 emergency dispatch — a real person answers, day or night.
2769 E Combs Rd, San Tan Valley, AZ 85140
Plumbing service
4.9★
168 customer reviews
60–90 min
Typical San Tan Valley response
Licensed & insured
Bonded Arizona contractor
15–18 gpg
Hard-water specialists
Repiping Services in San Tan Valley
The houses that do need one fall into clear categories. Homes with two or more pinhole leaks in the same copper system. Polybutylene-era homes in Florence, Apache Junction and southeast Gilbert, built between 1978 and 1995 with the gray plastic pipe that fails at the fittings. Galvanized-steel homes in Coolidge, Superior and older Casa Grande where the interior of the pipe has scaled down to the diameter of a pencil.
If you are in one of those categories, a repipe is not an upgrade — it is the fix. If you are not, we will tell you that and quote the smaller job instead.
Signs you need us
Copper that fails once from water chemistry and pressure will fail again. The second leak is the signal; the third is confirmation you have been paying to postpone the inevitable.
Common in 1978–1995 builds. It fails at the fittings and it fails without warning. Many insurers surcharge or decline homes that still have it.
If the pressure at the street is fine but every fixture in your house is weak, the restriction is inside your walls. Scale narrows the effective diameter of a pipe until a half-inch line flows like a quarter-inch. See [low water pressure causes and fixes](/blog/low-water-pressure-causes/).
Rust or sediment in the first draw points to galvanized steel corroding from the inside out.
Sometimes an arrestor problem, sometimes a symptom of a system under too much pressure — which is also what drives premature pipe failure. We check static pressure on every repipe estimate.
What you get
We install both. Here is how we advise, based on what actually happens to pipe in a San Tan Valley attic.
| PEX-A / PEX-B | Type L Copper | |
|---|---|---|
| Resistance to our water chemistry | Immune — no pinholes, no interior corrosion, no scale bonding to the wall | Vulnerable to pinholing over time, especially on the hot side |
| Attic heat performance | Rated well above summer attic temperatures; must be shielded from direct UV | Unaffected by heat, but expands and contracts and can tick against framing |
| Fittings and joints | Fewer joints per run; expansion or crimp fittings, no open flame in your attic | Soldered joints, more of them, torch work in an insulated space |
| Labor and cost | Lower — faster installs, smaller access holes, less drywall to repair | Higher material and labor cost |
| Water flow feel | Slightly smaller inner diameter per nominal size; we upsize where it matters | Excellent flow characteristics |
| Typical service life here | 50+ years with correct installation | 20–40 years depending on water chemistry and pressure |
For most homes here we recommend PEX-A with expansion fittings, run overhead through the attic with proper insulation and UV protection. It is the material least affected by the exact conditions that killed the original system. We still run copper where a homeowner wants it or where exposed sections need the look and rigidity — for example the visible risers in a garage or mechanical room. The longer comparison lives in PEX versus copper repiping in desert heat.
The honest version, so nothing on the schedule surprises you:
If your home was built between 1978 and 1995 — and much of Apache Junction, Florence and southeast Gilbert was — check under a sink for gray, flexible plastic pipe about the diameter of copper, usually with a stamp reading PB2110.
Polybutylene degrades from the inside when exposed to chlorinated water, and it typically fails at the fittings, without warning, at full line pressure. Insurance carriers know this. Many will not write a new policy on a poly home, and some that will exclude water damage from the plumbing system entirely. If you have it, replacing it is not a maintenance project — it is loss prevention.
A single-story San Tan Valley home with two or three bathrooms is typically a two to three day repipe, plus a day for drywall patching and texture. Two-story homes and larger floor plans in Encanterra or Pecan Creek run three to five days. You stay in the house the entire time. Water is restored each evening, and we work bathroom by bathroom so you always have a functioning one.
Cost is driven by fixture count, not square footage — a 2,400 square foot home with two baths costs less to repipe than an 1,800 square foot home with three baths and a wet bar. Our whole-home repipe cost guide breaks down the real variables.
How we work
Static pressure test, visual inspection of accessible pipe, review of your leak history and, where useful, a look inside a section of the existing line. Plenty of these visits end with 'you need a PRV and a softener, not a repipe.'
You get a written scope listing every fixture, every wall to be opened and every material. Fixed price, not time and materials, so a difficult day in your attic is our problem and not your invoice.
We pull the permit where required and coordinate the inspection. A repipe done without a permit is a disclosure problem when you sell.
New system installed overhead, pressure tested and held, then each fixture transferred. Old lines capped and abandoned. Water back on every evening.
Drywall patched and textured to match, jobsite cleaned, and a walkthrough at every fixture with you before we ask for final payment. Written warranty on labor and manufacturer warranty on materials.
What it costs
The single biggest driver. Every sink, tub, shower, toilet, hose bib, laundry box and refrigerator line is a termination point that has to be run and tied in.
Two-story homes require vertical chases and more wall openings, which adds both plumbing labor and drywall repair.
PEX-A versus copper is a meaningful cost difference on material and a larger one on labor. We quote both when you want to compare.
A walkable truss attic with good clearance is straightforward. A low-clearance attic packed with blown insulation is slower, hotter and harder — and in July it is genuinely brutal work.
Included in our quotes as patch, texture and prime. Full-room repainting is not, because most homeowners prefer to handle paint on their own schedule.
Pressure-reducing valve, softener loop, new angle stops and supply lines, and hose bib replacement all cost far less done during a repipe than as separate visits later.
Why Economy Plumbers
Post-2000 tract homes have decades left with a softener and proper leak repair. A repipe is right for repeat pinholes, polybutylene and scaled galvanised — and we will tell you when you are not in one of those categories.
You get a written scope listing every fixture, every wall and every material, at a price that does not move. A 115-degree attic in July is our risk to carry, not yours.
Not PEX-B with crimp fittings that restrict flow at every joint. Expansion fittings, fewer joints per run, and a material the local water chemistry cannot pinhole.
Knockdown and orange peel are the two textures on nearly every home in this town and we match both. Most repipe complaints we hear about other companies are drywall complaints.
Every repipe is inspected work. Skipping the permit voids most manufacturer warranties and follows you to closing when you sell.
Flat-rate pricing agreed before work starts, and we will tell you honestly if there is a cheaper answer.
Where this comes up most
Pinal County seat since 1875 with a National Historic District; pre-1995 housing makes polybutylene repipes and aging sewer laterals the core call driver.
Retiree and mobile-home mix at the base of the Superstition Mountains, where 1978–1995 polybutylene-era homes create high repipe and leak-repair density.
Southeast Gilbert's 1980s–90s family subdivisions fall inside the 1978–1995 polybutylene window, making whole-home repipes the signature job on this side of the border.
2000s boom-era stucco tract homes where hard-water scale has narrowed original pipe diameter, making low-pressure complaints the top service trigger.
We serve San Tan Valley and the surrounding Pinal County area — see every area we cover.
Questions we get
Three signals matter most: repeated pinhole leaks in the same copper system, gray polybutylene pipe from a 1978–1995 build, or house-wide low pressure that persists when the pressure at the meter is normal. One leak in a 2005 home is a repair, not a repipe — and we will say so.
Two to three days of plumbing for a typical single-story San Tan Valley home, three to five for a larger or two-story home, plus a day for drywall patch and texture. You stay in the house, and we restore water every evening.
For most homes in this water, PEX-A. It does not pinhole, scale does not bond to it, and it handles attic temperatures well when installed and insulated correctly. Copper remains a fine choice and we install it on request, but in 15 to 18 grain water it is the material that failed the first time.
Yes. Patch, tape, texture match — knockdown or orange peel — and prime are included in our repipe quotes. We leave final paint to you so you can match your exact color and sheen.
Yes. It fails at the fittings without warning and at full pressure, and many insurance carriers will not write or renew a policy on a home that still has it. If you find gray plastic supply pipe stamped PB2110 under your sinks, treat replacement as a priority rather than a someday project.
Related
Electronic and acoustic leak locating for post-tension slabs, then the least invasive fix: spot repair, reroute or repipe.
Learn moreAt 15–18 grains per gallon, softening is not a luxury here. Correctly sized systems, installed at the loop, with RO for drinking water.
Learn moreYour everyday plumber for repairs, installs, inspections and annual maintenance — with the local knowledge tract homes here need.
Learn more
Repipe pricing is driven by fixture count, not square footage. Here is every variable that moves the number, and how to compare three quotes that look nothing alike.
Read the guide
We install both. Here is the honest comparison in the specific conditions that matter here: 150-degree attics and water that already killed one copper system.
Read the guideFree estimate
Call and a real person picks up — day, night, weekend or holiday. Most in-town calls see a truck in 60–90 minutes.
